VBrick Systems VB4000 Series Manual de instrucciones descargar pdf (Pagina 127)

Diagnostics

VBrick WM Appliance Admin Guide 117

Diagnostics: Hard Drive

T To run Check Disk:

1. Go to

Configuration: System > General.

2. Set the

Configured Operational Mode to Diagnostics. (After you press Apply, the

appliance will reboot. Wait until the front panel displays "Diagnostic Mode.")

3. Go to

Diagnostic: Hard Drive and click Begin Edit.

4. Click

Start to run the utility. (Note that the Start button is only shown in Diagnostic

Mode.

5. Click

Refresh to see the results.

6. When done, reset

Configured Operational Mode to Run.

Hard Drive Format Use carefully. Removes all content and reformats the hard drive.

Check Disk Runs the Check Disk utility. You must be in Diagnostic Mode to

start Check Disk. See below.

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 155 156

Sin comentarios

VBrick Systems VB4000 Series Manual de instrucciones Pagina 127